How weak Wi-Fi can affect OPS-COM

Typical issues that affect Wi-Fi strength

Simple test to ensure you  are connected

When in the field patrolling it may be difficult to tell if you have enough signal strength to be confident that OPS-COM is communicating through Wi-Fi with the main server. A quick and easy test would be to go to the browser on your tablet to test connecting to any web page. If the browser can not connect to a web site it will not connect with OPS-COM. 

Syncing

First rule: Don't Panic! If you can't sync immediately, it's not a critical issue. As long as you perform a sync when you get to an area with better connectivity.

Manual Sync

The system is setup to sync information in two ways.

Through a forced manual sync that the patrol officer can initiate from the main menu entitled Synchronize Data.

image.png

Auto-Sync

Auto-Sync occurs in three different instances on the handheld unit.

On startup of the app a sync is performed automatically provided you have connectivity. If you have poor connectivity, OPS-COM will show an error and will not allow you to login.

On logging out of the app the unit will run an auto-sync. Be sure to log out properly for this to happen. Simply putting the app in the background will not run the sync. NOTE: Be careful not to close the app or power off the unit if the app is running in the background.

It's important to remember autosync is a precaution put into effect to ensure syncing happens when an officer has not done a sync in a while and the unit is idle. With a setting of 15 minutes, the unit would have to be idle for 15 minutes. if you have any use of the tablet in that time the timer restarts. So if your officers are active with writing tickets it's not going to auto sync until they leave the unit idle for the entire 15 minutes. The idle time frame can be modified in the system settings.

image.png


You can select various time intervals or disable auto sync all together.

image.png

It would be a good practice to return to the main menu and allow a sync or force a manual sync before logging out for the day at the end of your shift.

Was Syncing Successful?

The system has a built in indicator when there is data available to sync. A red flashing message will appear at the top of the screen indicating "Data available to sync:" and the number of violations and vehicles that need to be synced with the main server.

Once a proper sync has occurred the data available warning will disappear.

image.png


Revision #2
Created 29 April 2024 12:19:46
Updated 11 September 2024 13:40:49