Skip to main content

Parking Logix - Parking Sensor Integration

This article outlines how to configure and enable the Parking Logix integration within OPS-COM, allowing administrators to sync parking sensor data for real-time monitoring and display. This feature is intended for OPS-COM administrators responsible for system configuration and user-facing parking maps.

Setup and Configuration

Follow these steps to integrate Parking Logix sensors with your OPS-COM system.

Enable Parking Logix Integration

  1. Before you can use the Parking Logix integration on your system you will needNavigate to navigate to your Third Party settings under System Settings.

  2. FromSelect thereThird youParty shouldsettings.

    see

  3. Enable the option to enable Parking Logix Integration.
    checkbox.

image.png

Adding the Lot Group

  1. Next, addCreate a new lot group tofor youreach systemlot making surewhere you includeare collecting sensor data.

  2. Enter the required API code.code when configuring each group.

    • Note: It is possiblepossible, butthough unlikelyunlikely, thatto there will behave multiple API keys if lot access is split overacross several keys. 

  3. CreateNavigate ato specificthe groupLot forAdministration eachtool.

    lot
    4. you will be collecting data from.

image.png

  1. Once the Lot Group has been configured you would need to assign it to the lot onOpen the LPR Settings Tab offor the Lotdesired Administrationlot.

    tool.

  2. Assign the previously created lot group to the lot.

image.png

Enable the System Task

  1. AContact OPS-COM support by emailing support@ops-com.com to enable the required system task must be enabled for thesensor Parking Logix sensors to communicate with our system.communication.

    This

    2. must be enabled by OPSCOM integration staff and you can contact us through support to set this up. Please email support@ops-com.comcom for assistance.

  2. Once the system task hasis beenactive, run you should see updated onverify the lotintegration countsby undernavigating to Manage Parking Lot Groups
     to confirm that lot counts are updating correctly.

image.png


Displaying the Map on the User Side

Finally,To enterdisplay the parking map to end users, you must insert the integration short code on the user side to any ofinto your pagessite usingpages.

  1. Navigate to System Messaging.

  2. TheEdit the desired page where the map should appear.

  3. Enter the short code is [parking_logix] andinto youthe canpage passcontent.

    addition

    • You may add parameters such as:as only,only, show,show, filter,filter, or name.name to Thisthe willshort code to restrict the list to show only specific lots.

image.png

By design, itthe map will only showdisplay lots that have a group assigned toand ita thatvalid have an API key stored in it.
stored.

image.png


Best Practices and Considerations

  • Data Accuracy: Ensure that every lot intended for display is correctly linked to a lot group containing a valid API key, otherwise, the lot will not appear on the user-facing map.

  • Support Coordination: Because the system task must be enabled by the OPS-COM integration team, initiate your support request early in your setup process to avoid delays in data synchronization.

  • Parameter Usage: Use the filtering parameters within the [parking_logix] short code to provide users with a clean, relevant view of specific parking areas rather than the entire system inventory.

Back to top